 |
| | |||||||||||||||||||||||||||
| | Thread Tools | Search this Thread | Display Modes |
| #1  10-Aug-2012, 17:37 | ||||
| ||||
| Tacho wiring/conversion help please Ok. I have a tacho for a 900 monster which is activated by the ECU. I want to fit this to a carby 900. Now according to an earlier post the ECU type tacho will not run from the carby pickups/coils. However, my engine is a injection to carb conversion so still has the crank sensor pickup mount which I think is responsible for activating the ECU type tacho? Can I wire the injection crank sensor in such a way that it produces a signal (without an ECU) for the ECU activated tacho to run properly? I tested the 996 sensor and seems to only receive 2v with the ignition on which may cause a problem. Thanks.   |
Threaded Mode