| Checked all ecu power supplies at body 27, 17 and 4 pins, all good and comparable. Rechecked ecu earth at body 38 via sidestand switch, tried jury wiring it to be double sure. Checked eng earth, ecu earth again, battery earth, tried new fuses when reseating them, still the same.
Although I have measured resistance through the sensors from the ecu connectors I do not know the correct values but all seemed reasonable and as expected. Does anyone know if either the throttle position sensor, air temp sensor or water temp sensor would inhibit starting if faulty? You mentioned you had a problem with an air pressure sensor once dunlop o. Anyone know the sensors correct values?
Also will try pin pull-off check and then insulation check of the rest of the ecu wiring wire to wire and wire to ground. | 
31-Mar-2014, 21:14 
Threaded Mode