quick question

duck · 16-Aug-2005, 08:01

will the 748/916 etc carbon (or any) clutch cover fit a 749

butch890 · 16-Aug-2005, 08:44

Yes it will ,if you're into that kind of thing!(i'm not!!!)

Butch

swannymere · 16-Aug-2005, 13:16

velocity

duck · 16-Aug-2005, 20:45

nice 1

Carbon749 · 16-Aug-2005, 21:12

My clutch cover is a modified 748 carbon cover ....

duck · 17-Aug-2005, 07:58

i take it that the cover bit is modified not the mounting holes

andyb · 17-Aug-2005, 10:09

Duck, the main resistance your getting here is that although a carbon clutch cover looks nice, it offers no protection whatsoever to a right hand lowside fall.

The point is any drop will be expensive, with no protection over your clutch you run the extra risk of double the expense with untold damage to your clutch and beyond!

duck · 17-Aug-2005, 17:10

andyb thank you for pointing out the obvious (just pulling your chain

)
i've learned most things i look at and think YES unfortunately tend to be expensive and impractical like 750cc underpowered sbk's (i'll just get my coat). not sure what you mean by resistance? i'm only asking because i'd seen a few clutch bits for the 748 series on ebay going cheaper than ones for the 749 series. if they're the same why pay more?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

16-Aug-2005, 08:01	#1
duck Registered Forum User Mille Posts: 143 Join Date: May 2005 Location: norfolk quick question will the 748/916 etc carbon (or any) clutch cover fit a 749 Reply

16-Aug-2005, 08:44	#2
butch890 Registered Forum User Big Twin Posts: 1,602 Join Date: Jun 2003 Location: kettering Mood: Enjoying Togdom ! Yes it will ,if you're into that kind of thing!(i'm not!!!) Butch Reply

16-Aug-2005, 13:16	#3
swannymere Registered Forum User Big Twin Posts: 1,863 Join Date: Apr 2005 Location: Winchester-ish Mood: High as a kite! velocity Reply

16-Aug-2005, 20:45	#4
duck Registered Forum User Mille Posts: 143 Join Date: May 2005 Location: norfolk nice 1 Reply

16-Aug-2005, 21:12	#5
Carbon749 Registered Forum User Big Twin Posts: 1,956 Join Date: Mar 2005 Location: Normally in my own little world Mood: I own a flame thrower My clutch cover is a modified 748 carbon cover .... Reply

17-Aug-2005, 07:58	#6
duck Registered Forum User Mille Posts: 143 Join Date: May 2005 Location: norfolk i take it that the cover bit is modified not the mounting holes Reply