Will it fit - 996 clutch casing

Carbon749 · 17-Nov-2005, 20:20

Hi,

Would anyone know if a clutch casing from a 996 will fit a 2003 749 ? They look the same, but, not sure if they fit the same.

nelly · 17-Nov-2005, 21:11

The oil feed for the heads on the 'stretta engine is taken off a dedicated oil port on the casing.
The 996 is fed via the cooler so i'm afraid it'll be no good to you.

Carbon749 · 17-Nov-2005, 21:51

Cheers Nelly, top advise again. Spotted a 996rs machined one on e-bay for cheap money.

Best get the files and dremel out

bike mad · 21-Nov-2005, 17:36

nelly well done 9 1/2 out of ten,is good when you get this level of advice.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

17-Nov-2005, 20:20	#1
Carbon749 Registered Forum User Big Twin Posts: 1,956 Join Date: Mar 2005 Location: Normally in my own little world Mood: I own a flame thrower Will it fit - 996 clutch casing Hi, Would anyone know if a clutch casing from a 996 will fit a 2003 749 ? They look the same, but, not sure if they fit the same. Reply

17-Nov-2005, 21:11	#2
nelly Registered Forum User Ducati Corse Posts: 3,134 Join Date: Jan 2002 Location: notts Mood: Bloo and Yellow.. and Red now ;) The oil feed for the heads on the 'stretta engine is taken off a dedicated oil port on the casing. The 996 is fed via the cooler so i'm afraid it'll be no good to you. Reply

17-Nov-2005, 21:51	#3
Carbon749 Registered Forum User Big Twin Posts: 1,956 Join Date: Mar 2005 Location: Normally in my own little world Mood: I own a flame thrower Cheers Nelly, top advise again. Spotted a 996rs machined one on e-bay for cheap money. Best get the files and dremel out Reply

21-Nov-2005, 17:36	#4
bike mad Registered Forum User Mille Posts: 297 Join Date: Jun 2005 Location: just out side sidmouth in devon nelly well done 9 1/2 out of ten,is good when you get this level of advice. Reply