Clutch problems

DAZZERS FE · 05-Jun-2006, 08:43

Hi

could anyone tell me if a clutch from a 2005 749 would fit my 2004 998s FE.

I think the clutch would fit but I don't know if the plates would be the same, ie would the pressure/grip be good enough for the bigger motor or would it just slip.

Thanks

Dazzer

DAZZERS FE · 05-Jun-2006, 12:23

Hi

Does anybody have any ideas

Cheers

Dazzer

yeti · 05-Jun-2006, 14:35

Should fit ok. You might need to play about with plate sizes to get the right stack height - usually 38mm, but it is do-able. Only other thing to note is shaft size, the S MAY have a 25mm shaft in which case you may or may not need a spacer and a new nut. Hope this helps.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

05-Jun-2006, 12:23	#2
DAZZERS FE Registered Forum User Posts: 30 Join Date: Jan 2006 Location: Gloucestershire Mood: Need to get out on the 998 Hi Does anybody have any ideas Cheers Dazzer Reply