What is the Torque Setting? Clutch

peterg · 31-Aug-2004, 15:31

I am awaiting the arrival of a load of carbon and alloy parts from Casoli.

One of which is the red anodised clutch pressure plate.

I would like to know what the clutch springs should be Torqued down to??

Thanks

Peter G

nelly · 31-Aug-2004, 15:45

8 or 9 Nm. No tighter, and make sure you apply a good smear of Copaslip to the threads. They are buggas for seizing and then the heads rounding out.

rockhopper · 31-Aug-2004, 15:46

Someone will be along soon with the right answer but the Rockhopper answer is not very tight. An ordinary allen key will do if you dont have a torque wrench. The weight of my 12 inch bar was enough to snap one of the bolts on my ST2.

Shazaam! · 31-Aug-2004, 15:46

5 INCH-pounds to avoid stripping the threads. The spring tension will prevent them from loosening.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

31-Aug-2004, 15:31	#1
peterg Registered Forum User Posts: 43 Join Date: Jul 2004 What is the Torque Setting? Clutch I am awaiting the arrival of a load of carbon and alloy parts from Casoli. One of which is the red anodised clutch pressure plate. I would like to know what the clutch springs should be Torqued down to?? Thanks Peter G Reply

31-Aug-2004, 15:45	#2
nelly Registered Forum User Ducati Corse Posts: 3,134 Join Date: Jan 2002 Location: notts Mood: Bloo and Yellow.. and Red now ;) 8 or 9 Nm. No tighter, and make sure you apply a good smear of Copaslip to the threads. They are buggas for seizing and then the heads rounding out. Reply

31-Aug-2004, 15:46	#3
rockhopper Registered Forum User Ducati Corse Posts: 3,367 Join Date: Jul 2001 Location: Pinxton Someone will be along soon with the right answer but the Rockhopper answer is not very tight. An ordinary allen key will do if you dont have a torque wrench. The weight of my 12 inch bar was enough to snap one of the bolts on my ST2. Reply

31-Aug-2004, 15:46	#4
Shazaam! DSC Club Member Big Twin Posts: 1,167 Join Date: Nov 2001 Location: San Diego, CA 5 INCH-pounds to avoid stripping the threads. The spring tension will prevent them from loosening. Reply