Ducati Sporting Club UK
 
 
Thread Tools Search this Thread Display Modes
  #1  
Old 03-Feb-2015, 17:47
dave998 dave998 is offline
Registered Forum User
 
Posts: 36
Join Date: May 2006
1199 Panigale Side stand switch

Hi all especially Nelly!

Anyone know which of the three wires on the side stand switch I join together to by pass it?
There's Brown/Violet
Orange
Black

Also removing the rear light unit to fit a race unit,how do you get round the error code flagging up on dash? because it can't detect the light anymore.

Cheers
Quote+Reply
  #2  
Old 23-Aug-2015, 13:42
STEVENSON-KAATSCH STEVENSON-KAATSCH is offline
Registered Forum User
Newbie
 
Posts: 2
Join Date: Aug 2015
...as far as the tail-light goes...

Ducati uses something called a CanBus wiring system. Put simply, every sensor output and command input goes through the Electronic Control Unit (ECU), and as such, any deviation from an expected response from the tail end of your bike, such as unplugging the tail lights, will make it shout 'foul' ! Just as in the LPG conversion industry, where petrol engines are persuaded to run on Liquid Petrolium Gas, one has to disconnect the petrol injectors without letting the ECU know we have done so. The answer is to fit an 'Emulator', to reproduce the same electrical response petrol injectors have and put the gaseous substitute into the air flow instead. Ignoring the gas, as it is irrelevant to this matter, the Emulator is simply a group of resistors, one per injector, which gives the ECU the answer it is expecting for every electrical squirt of current given out. It expects a certain electrical resistance and it gets it. The Ducati ECU needs a similar thing as a surrogate tail lamp. Measure the electrical resistance of your tail lamp.... it might even be written on it or specified in some of Ducati's literature and get a suitable resistor from your friendly local supplier or the Internet. Then get some suitable electrical connectors (needn't be the whole plastic plug) and make up the connections. Remember to insulate everything... heat shrink is a good product for this.
Quote+Reply
  #3  
Old 23-Aug-2015, 13:49
STEVENSON-KAATSCH STEVENSON-KAATSCH is offline
Registered Forum User
Newbie
 
Posts: 2
Join Date: Aug 2015
....side-stand switch....

....just looked at the first bit of the question. No need to be sophisticated, just remove the switch unit from the side stand after determining where 'off' is (when the stand is up) and glue/cable-tie/sticky-tape it in position, then cable-tie the loose wires away from moving or hot things. Job done.
Quote+Reply
  
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes
Postbit Selector
Switch to Vertical postbit Use Vertical Postbit

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Recent Posts - Contact Us - DSC Home - Archive - Top
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2024, Jelsoft Enterprises Ltd. - © Ducati Sporting Club UK - All times are GMT +1. The time now is 07:19.