| New Clip-Ons
My original clip-ons are going rusty so I brought a pair of Italian RobbyMoto Alu clip-ons from ExtremeByke Sportz at Ally Pally – these are the raised type (but a bit lower than the originals).
Tried to fit them today and had a few probs. Managed to get everything off (in the end – seized switch screws caused a bit of cursing).
Biggest prob is the brake master cylinder. F I slide the cylinder up the bars to the end closest to the ignition switch (where it was originally) it hits the raised part of the bar. This mean I have to move it out a couple of inches. It all works OK but doesn’t look so good.
Any suggestions? | 
Threaded Mode