| Clutch plate stack height.
My new clutch plates have arrived and now I have plenty of thicknesses to play with.
To get my stack height to 36.5mm I have the following order =
From the cranckcase outwards -
1 Steel 1.5mm
2 Friction
3 Dish - dot facing pressure plate
4 Friction
5 Steel 2mm
6 Friction
7 Steel 2mm
8 Friction
9 Steel 2mm
10 Friction
11 Steel 2mm
12 Friction
13 Steel 2mm
14 Friction
15 Dish - dot facing crankcase
16 Friction
17 Steel 1.5mm
This gives me a perfect 36.5mm according to my Vernier
Does this order sound OK before I re-assemble?
I'm thinking of the two 1.5mm at either end of the stack or should they be towards the centre with 2mm steels at either end?
[Edited on 15-6-2005 by everton] | 
15-Jun-2005, 14:47 
Threaded Mode