Quote:
Originally posted by antonye
You still need to get those cone nuts off the ignition?
Get the right sized bolt to fit into the thread of the cone nut, about 40mm long or so will do, then wind a nut onto it.
Now wind the nut and bolt into the threaded cone so you've got lots of thread in there, then wind the nut up to the cone and tighten it right up.
Now you can start to undo the bolt and it should undo the cone nut. If not, tighten up the nut some more and try again.
Finally hold the bolt and slacken the nut, then you can spin off the cone nut.
HTH. |
Have you taken something?
Threaded Mode