| From memory....one plug goes to the fuel pump - this fits in at the connector under the tank, the plugs are paired together with a male female combination to go in between the two halves of the plug at the tank.
The other pair fits in between the two halves of the plug from the right hand handlebar controls.
There is obviously the power feed and the led to sort out too and you will also have a loop which can be connected to an antitamper switch.
The best place I found for the motion detector was adjacent to the ECU under the seat with the detector aligned across the frame.
I may have the installation instructions somewhere...I'll have a look in the garage a bit later.
Hope this helps
Andy | 
Hybrid Mode
