| Right, latest update: -
Firstlly have found that the top of my struts look different to any other photo I've seen as the inner section remains flush with the outer section regardless of setting.
If we assume that there are 16 turns from hard to soft, the left strut was approx 11 off hard and the right 15.
To get the sag to 30mm I have gone to 5 off hard.
Also confused about the strut height through the stock.
I am sure that I've read that it should be FOUR rings when viewed from the inside of the strut, however mine are at THREE.
Is anyone out there using Ohlins, and if so what are yours set at?
Will check the rear ride height tomorrow (thanks Mike) and see where that is.
Ta
[Edited on 4-6-2005 by L3OONY] | 
Threaded Mode