| Take off clutch cover.
Undo all 6 spring bolts doing this even number of turns each so they loosen at roughly the same rate.
Remove bolts, spring caps & springs.
You may need to use a small drift like an old jewellers screwdriver to punch the clutch pushrod out of the centre of the pressure plate.
Remove pressure plate.
When you come to put the new plate on, align the dot on the edge of the plate with the spring post which has a line through the end & ensure the pushrod is seated properly.
Insert new springs caps & bolts & tighten down evenly.
Enjoy.
It's dead easy... while it's out you may as well clean up the plats if you feel up to it... just don't breathe in the dust!! | 
Threaded Mode