Bleeding Underslung Rear Caliper Conversion !

999TREV · 05-Jun-2006, 21:04

has anyone tried to get the ducati rear stand under the swingarm after installing one of these brkts on an early 999

andyb · 06-Jun-2006, 01:06

I use a 998 side entry stand anyway, and allways did even with the old swing arm! The 999 later bobbin type stand still fits..........

iang · 06-Jun-2006, 14:00

Andy, does the 998 single side stand fit into the wheel spindle or does it need to be machined to suit ?

I always found the single sided stand much easier to use when you are alone, I dread lifting and lowering the bike by myself with my micron stand even with the large R&G bobbins fitted.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

05-Jun-2006, 21:04	#1
999TREV Registered Forum User Posts: 42 Join Date: Jan 2006 Location: Hemsby Norfolk Mood: Always red has anyone tried to get the ducati rear stand under the swingarm after installing one of these brkts on an early 999 Reply

06-Jun-2006, 01:06	#2
andyb Registered Forum User BSB Star Posts: 6,720 Join Date: Feb 2002 Location: northampton Mood: Has change happened...must of missed it! I use a 998 side entry stand anyway, and allways did even with the old swing arm! The 999 later bobbin type stand still fits.......... Reply

06-Jun-2006, 14:00	#3
iang Registered Forum User Big Twin Posts: 1,170 Join Date: Jan 2003 Location: northumberland Andy, does the 998 single side stand fit into the wheel spindle or does it need to be machined to suit ? I always found the single sided stand much easier to use when you are alone, I dread lifting and lowering the bike by myself with my micron stand even with the large R&G bobbins fitted. Reply