Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Oil light at idle

[Shazaam!]

As a first step, you should carefully straighten any oil cooler radiator fins that are bent from road debris so you get the maximum cooling from the unit. After you straighten them, attach some protective screening to the backside of the V-piece to prevent future damage.

As your oil temperature rises during a track session its viscosity drops and engine oil pressure drops slightly. If you have low oil pressure (as opposed to a bad pressure switch) usually what happens is that initially the oil light will start to flicker after riding hard on the track, but not under normal commuting type riding. Under these conditions you should be using a 50-weight viscosity oil to maintain an adequate oil pressure and use a synthetic oil to give yourself a safety net against oil breakdown at higher temperatures.

[Dizmo]

My 996 does this after hard/track riding because its using oil. Top it up and its fine again and it uses no oil at all riding normally. There seems to be no power loss or nasty smoke. Is there something I can do about it, or do I just have to keep chucking oil in her? It has done 27k though

[moto748]

You're lucky to have a warning light!

Mine popped the switch our of the thread in the casing (not uncommon, apparently). It's been replaced by a superb bodge with a bolt and nyloc nut

It's due an oil change, though, and it's always nice to see that red light extinguish after you've filled her up and fired her up.

I'll have to get around to getting the casing helicoiled.