749R slipper clutch pressure plate measurement required ?

doogalman · 02-Aug-2006, 13:12

Bit of a misrepresentation with the number plate . Should be fitted to a 999 not a 749. WSS would have been the one!!!!!

Sharpy G · 02-Aug-2006, 13:16

Quote:

Originally Posted by doogalman

Bit of a misrepresentation with the number plate . Should be fitted to a 999 not a 749. WSS would have been the one!!!!!

erm....it does say SBK on the tank
and its in Ducatis SBK section aint it ?!

toys out of pram .!....................it is a Superbike ! yes it is !!

Sharpy G · 02-Aug-2006, 13:16

BY THE WAY.......for anyone reading this, I do still need the measurement at the beginning of this rambling post

LOL

doogalman · 02-Aug-2006, 14:12

Steady tiger!!!

Sharpy G · 02-Aug-2006, 14:33

Quote:

Originally Posted by doogalman

Steady tiger!!!

Only kidding mate, just made me laugh that I got all these relpies but no dimension

G

Gizmo · 02-Aug-2006, 14:52

Quote:

Originally Posted by Sharpy G

Only kidding mate, just made me laugh that I got all these relpies but no dimension

G

DPP slipper plate is 115mm internal diameter i'd think the 749R would need to be the same as the basket will be same tooth outside diameter.

Sharpy G · 02-Aug-2006, 15:02

Gizmo
thanks, it is 115mm dia inside of teeth, but I need to know what the diam is on the 749R one without the teeth so I can machine them off
cheers

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

02-Aug-2006, 13:12	#1
doogalman Registered Forum User WSB Hero Posts: 9,937 Join Date: May 2003 Location: Enjoy as much time without work Mood: No point in working long hours to die early Bit of a misrepresentation with the number plate . Should be fitted to a 999 not a 749. WSS would have been the one!!!!! Reply

02-Aug-2006, 13:16	#3
Sharpy G Registered Forum User Ducati Corse Bikes: 749R 2004 Posts: 3,459 Join Date: Dec 2005 Location: Redhill, Surrey Mood: luvin' bein back out on the 'R' BY THE WAY.......for anyone reading this, I do still need the measurement at the beginning of this rambling post LOL Reply

02-Aug-2006, 14:12	#4
doogalman Registered Forum User WSB Hero Posts: 9,937 Join Date: May 2003 Location: Enjoy as much time without work Mood: No point in working long hours to die early Steady tiger!!! Reply

02-Aug-2006, 15:02	#7
Sharpy G Registered Forum User Ducati Corse Bikes: 749R 2004 Posts: 3,459 Join Date: Dec 2005 Location: Redhill, Surrey Mood: luvin' bein back out on the 'R' Gizmo thanks, it is 115mm dia inside of teeth, but I need to know what the diam is on the 749R one without the teeth so I can machine them off cheers Reply