Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 999 / 749 > 749R slipper clutch pressure plate measurement required ?

[Gizmo]

Originally Posted by Sharpy G

Gizmo
thanks, it is 115mm dia inside of teeth, but I need to know what the diam is on the 749R one without the teeth so I can machine them off
cheers

the 749R should be the same, the teeth are on the basket and the basket is the same between bikes cos the clutch plates fit between bikes. So, if the DPP slipper has clearance from the basket teeth the same machined out diameter will work on any slipper pressure plate as it has to clear the same teeth, if you get my drift....

if that ain't enough try measuring across the teeth on your final steel plate, and leave a little clearance, if its close to 115 I'd probably go with that