There's a hole in my T8!

khushy · 15-Sep-2006, 19:29

748 SPS used to weap a little oil from that rear gasket - we managed to (in situ) lift the rear cylinder slightly and seal it with some liquid gasket stuff - never leaked again!

Khushy

Mr.R · 15-Sep-2006, 19:45

Hi, The oilfeed is for the 900 two valve motors (common part) it's not used on the 4 valvers,but it's still under presure. It's ok to blank it off with a grub screw thus doing away with the chance of it leaking!
Steve

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

15-Sep-2006, 19:29	#1
khushy Registered Forum User 500SD Posts: 516 Join Date: Mar 2005 Location: Glastonbury my old . . . 748 SPS used to weap a little oil from that rear gasket - we managed to (in situ) lift the rear cylinder slightly and seal it with some liquid gasket stuff - never leaked again! Khushy Reply

15-Sep-2006, 19:45	#2
Mr.R Registered Forum User GTL Posts: 474 Join Date: Aug 2006 Hi, The oilfeed is for the 900 two valve motors (common part) it's not used on the 4 valvers,but it's still under presure. It's ok to blank it off with a grub screw thus doing away with the chance of it leaking! Steve Reply