Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > Monsters > What are the monster standard supension settings?

Kit was about £20ish i think.

I only get a little bit of a wobble at 100+ in a straight line on the motorway which is getting near the limit of what an M600 will do anyway so i don't worry about it, don't notice any other instabilty on other roads. Dougducati might get a bit more with the forks dropped lower. From what i've seen and read alot of suspension set up is trial and error as the best set up is individual for the size and weight of rider.

Shandy

[Zimbo16]

I found fork tops level with clamps (for maximum ground clearance) and rose joints wound out about 12 - 15mm (I put a second locknut on to support them). Adjust preload till bike compresses around 28mm from fully extended (no weight on rear wheel at all) to compressed under normal rider's weight, measured at rear axle. Rebound fully clockwise then back off about 7 clicks.