749 13 Tooth front sprocket - Any good?

khushy · 23-Oct-2006, 10:01

dont know about that but I think if you go to a 13 on the front it will start to wear the front of the actual swing arm out as the chain will end up too close!!

I run 14/36 on my 05 999s - frisky is the word!!!

Khushy

duck · 23-Oct-2006, 14:47

cant do it, 14 is the minimum. i run a 42 on the back of my 749s and it's now much more usable on the road. suprised my mate on his zx6 as well

bike mad · 23-Oct-2006, 19:48

I run my bike a 999S with a 13 and it was fine, but when I did the chain I went up on the rear and went back to a 14 on the front, what I think is you can run a 13 but do the back if you can, I did not care about the chain as I would have to buy a new one if I was to go up 3 teeth on the rear anyway, so the wear was not a problem,my chain lasted 10'000 and 7'000 was with 13 on the front,

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

23-Oct-2006, 10:01	#1
khushy Registered Forum User 500SD Posts: 516 Join Date: Mar 2005 Location: Glastonbury Chain-Strain . . . dont know about that but I think if you go to a 13 on the front it will start to wear the front of the actual swing arm out as the chain will end up too close!! I run 14/36 on my 05 999s - frisky is the word!!! Khushy Reply

23-Oct-2006, 14:47	#2
duck Registered Forum User Mille Posts: 143 Join Date: May 2005 Location: norfolk cant do it, 14 is the minimum. i run a 42 on the back of my 749s and it's now much more usable on the road. suprised my mate on his zx6 as well Reply