Quote:
Originally posted by nelly
End float on the shaft should be 0.1mm +/- 0.05mm. Does the shaft rotate OK? Could be a bearing that has gone? If not, then it's down to the shimming of the shafts.
Spotted this on a customers bike and after a lot of arguing with Ducati I believe he got it rectified under warranty. The shaft had never seen a shim!!!
Have you seen any "shim like" bits in the oil? It could have broken and fell out? |
Nelly, thanks for the response...I was
hoping that you would reply.
Does the shaft rotate OK?
Yes, it's fine Could be a bearing that has gone?
I don't think so Have you seen any "shim like" bits in the oil?
No, oil change about a month ago was fine! My bike is miles out of warranty (1996)..
I wil get a dialgauge and quantify the actual float.
What do you think could have caused this (never have run the chain too tight, it's always on the loose side of just right!)and if it HAS lost a shim, will it lead to shaft seizure etc??
Cheers,
Richard
Threaded Mode