Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > 996 Deep sump conversion

[skidlids]

Can you modify the casing I thought you needed the Sandcast Corse casings for the sump to fit to.

[tez996]

I'm not sure? I've seen pics, bits of the cases are fettled away in side so not to create a pocket that doesn't fill with oil as quick so causing starvation, poss??? :0( And where there is 3 squire holes to fix the deep sump to, poss???

Might have some pics? I'll have a look and post them later

[head chief]

If a 996 engine is to be stroked 2mm using ti rods the timing gear shaft needs to be trimmed a bit to clear the con rods.

Trying to make standard 996 cases to fit a bolt on deep sump is a mission. Lots of machining and just the magnisium pick up pipe and special oil filter together is near 500 quid plus the mag sump and machine work to make it all fit.

If your looking to build a bomb proof bottom end then this could be a good idea - http://cjsracing.co.uk/Bryan%20Jacques.htm

[tez996]

I did wounder about going that route as it would be much cheaper, Hmmm???

[skidlids]

Originally Posted by head chief

If a 996 engine is to be stroked 2mm using ti rods the timing gear shaft needs to be trimmed a bit to clear the con rods.

Trying to make standard 996 cases to fit a bolt on deep sump is a mission. Lots of machining and just the magnisium pick up pipe and special oil filter together is near 500 quid plus the mag sump and machine work to make it all fit.

If your looking to build a bomb proof bottom end then this could be a good idea - http://cjsracing.co.uk/Bryan%20Jacques.htm

I know Bryan quite ell as we have raced against each other quiote a bit in North Glos's Sound of Thunder series and he really does have a strong quick motor for which he Credits Chris for.
Last time I spoke to Bryan was when he turned up at the New Era meeting at Pembey when DD was racing there last year and I had the odd cuppa with him and his wife and he was telling me how little looking after the engine required.
Certainly an option worth considering, I have seen the mag sumps go for quite a bit on Ebay and after Dallas blew his 996 Corse based engine up those bits sold very quickly when he decided it was beyond repair so switched to a 998R