Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > 748 wobbly rear wheel.. help

[injected]

It's unlikely to be bearings after just 8k miles (but anything's possible I suppose). I would start by taking off the wheel (making a mental note of the tightness of the nut) and looking for damage to the back face of the wheel and drive pin holes. If the nut's been loose there is likely to be secondary damage to the wheel I'm afraid, but you might get away with using the 'spare' drive pin holes.

Don't ride it until you've fixed the problem.

Good luck!! PS, if you fill in your location I'm sure one of us will help get the problem fixed. Bit difficult to offer not knowing where you are.

[KeefyB]

Yep,make sure the pins on the hub are correctly inserted into the holes in the wheel.They are fairly easy to miss and then the pins sit in the machined grooves.Done it myself when I got distracted while fitting the rear wheel on my old Multistrada.(Found my mistake before riding it tho!)

[nelly]

Wheel nuts can/do come loose but stay in place because the safety clip is doing it's job. The nut can even feel tight because it's nipped up on the clip.
8/10 this usually leads to the drive pins being damaged or sheared. Worst case is that the hub of the wheel gets mullered.....
get it took off and you'll know from there.

[spinoli1]

Has the wheel been powder coated? If yes, check that the surface under the conical spacer was masked off, otherwise the coating can crush and allow the nut to work loose. Personal experience.

Spin