wheel spindle/crash bung help

Jasper · 23-Aug-2009, 18:32

Yes mate.just don't have a spare wheel spindle!

Quote:

Originally Posted by Jools

Could you not use a spare standard axle, get some holes drilled and tapped in each end to take a suitable bolt for the protector? Something like an M8 thread about 10mm long in a 17mm axle wouldn't compromise the strength I wouldn't have thought, especially when there was a bolt in it.

Just a thought. An engineering whizz might be along in a minute

burtsp5 · 18-Sep-2009, 23:52

Hi Jasp,

send me down all the measurments and i'll run one off for you at work, no worries.I'll drill and tap out the threads at 8 mm /1.25 pitch so you can fit them straight in.

Jasper · 19-Sep-2009, 10:29

Hi Guy,

Thanks for the offer mate,but I'm ok with lathes,mills and shaping machines.Thanks anyway.

Quote:

Originally Posted by burtsp5

Hi Jasp,

send me down all the measurments and i'll run one off for you at work, no worries.I'll drill and tap out the threads at 8 mm /1.25 pitch so you can fit them straight in.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

18-Sep-2009, 23:52	#2
burtsp5 DSC Club Member Mille Posts: 115 Join Date: Jan 2006 Location: frome somerset Mood: Was broke, but getting better!!:) Hi Jasp, send me down all the measurments and i'll run one off for you at work, no worries.I'll drill and tap out the threads at 8 mm /1.25 pitch so you can fit them straight in. Reply