Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 999 / 749 > 749 warning lights

[KeefyB]

That will be the EOBD warning light.Its telling you there is a fault somewhere.You can bring up the fault codes by holding down the l/h button on the clocks while you turn on the ign.Here's a list of fault codes;
http://www.ducatisti.co.uk/forum/duc...ror-codes.html
Probably not too much to worry about,.....it could be something simple like low battery on tickover,a badly adjusted clutch switch,or sometimes if you roll backwards slightly it can confuse the speed sensor.Other common faults are front coil shorting or fuel pump relay.

[deej]

Originally Posted by KeefyB

That will be the EOBD warning light.Its telling you there is a fault somewhere.You can bring up the fault codes by holding down the l/h button on the clocks while you turn on the ign.Here's a list of fault codes;
http://www.ducatisti.co.uk/forum/duc...ror-codes.html
Probably not too much to worry about,.....it could be something simple like low battery on tickover,a badly adjusted clutch switch,or sometimes if you roll backwards slightly it can confuse the speed sensor.Other common faults are front coil shorting or fuel pump relay.

Cheers keefyb,had a feeling you'd be the first to reply. Will flick the switch later on and see what code comes up and go from there. Should it be done with engine running or engine off ?? Will also save the link to my favourites,hopefully won't need to use it too many times lol

[KeefyB]

No need to start the bike.Just hold the button down as you turn on the ign.

[deej]

Keefy

I've done as you said but can't see a code anywhere. All that happens when I hold the left button down is I end up being able to change the time on the clock. Wasn't too worried about it but this avo it came on permenantely so I tried your advice but no sign of a code anywhere. Any ideas on where I'm going wrong/not looking ??

[chrisw]

Only works if the EOBD light is illuminated. Sounds like it has cleared itself. Probably the 34.0 fault that crops up now and again, then clears itself.

Just google it and read the posts.

[deej]

cool,its very weird

in case the light stays on permanently tomorrow where will the code flash up, in the temp gauge like on a gsxr ???

[chrisw]

It will be on the LCD display instead of the normal read out. The code is bottom right.