Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 1198 / 1098 / 848 > Poor running problem then got better?

[skidlids]

Check all connectors are tight especially the large onethat connects to the ECU.

This year at the DSC Cadwell trackday my 996 would just die after I had used it in a wet session, never did find out what that was as it was fine when I got it home and has since been out on quite a few rideouts and runs to work

The Year before I had a lack of power that was caused by a blocked fuel filter which is what happens when you leave your trackday tank standing for to long

and a few years ago again at Cadwell we thought Dallas's 996 had a ignition pickup problem but that was traced to the main ECU connector working loose

[pbrown]

I was going to go round & check the connectors but not sure I would have done the ECU as it looks like it shouldn't come loose.
My 996 was always cutting out but wasn't cured by turning it on & off. That was down to a bad connector on the side stand relay.

[final_edition]

My 998 was cutting out on a trackday. It was traced to too big an air gap on the ign pick-up sensor.

[pbrown]

Originally Posted by final_edition

My 998 was cutting out on a trackday. It was traced to too big an air gap on the ign pick-up sensor.

Was it cutting out all the time or just intermittantly?