Wont start

smilo006 · 14-Feb-2011, 10:43

The only reason I can think of is that the wire was crushed or broken whentrying to ge tthe tank off. Perhaps pulled the tank and forgot to disconnect the fuel pump connector. The shroud round the wires appeared to be damaged. Looked like it had been torn.
However as with all these situations you learn something.
Know how to test electrical circuits, use a volt meter, how to check and change the fuel pump, reuse the o ring, etc. Just annoying though.

bradders · 14-Feb-2011, 11:17

its nearly always something simple, just frustrating it takes so long to find it!!

skidlids · 15-Feb-2011, 00:55

I've come across a few problems caused by people removing alarms or having them removed. Usually they are cut into the fuel and starter circuits and when removed the remaking of the circuit can be a bit of a bodge at times

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

14-Feb-2011, 11:17	#2
bradders Registered Forum User MotoGP God Bikes: 848, M620 DD bike Posts: 11,913 Join Date: Aug 2003 Location: Hants Mood: waiting... its nearly always something simple, just frustrating it takes so long to find it!! Reply

15-Feb-2011, 00:55	#3
skidlids MotoGP God Posts: 18,275 Join Date: Apr 2002 Location: Oxford Mood: Its ONLY a Bike Club I've come across a few problems caused by people removing alarms or having them removed. Usually they are cut into the fuel and starter circuits and when removed the remaking of the circuit can be a bit of a bodge at times Checkout the Desmo Due Paddock on Facebook Reply