Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Help identifying this slipper clutch 998

[jacknash]

Hi thanks for info. Not sure if ball n ramp, need tool to get basket off! So if I get at least one dished plate (where?) And same number of friction plates and build to 37mm the job should be a goodun?

[jacknash]

Steels under pressure plate

[skidlids]

If it was my bike I Would still rather dump the extra 1.5mm Steel and change 3 of the other 1.5mm plates to 2mm, you have the same overall pack thickness


This is how I see it

Lets assume a clutch lift of 3.8mm
Your setup had 19 plates so thats 3.8mm/19 = 0.2mm gap per plate

I would rather have 18 plates so that you get 3.8mm/18 = 0.21mm gap per plate

Might not sound a lot but that extra 0.18mm of clearance across the pack can help reduce drag and the risk of cooking the clutch

[jacknash]

hi skidlids, thanks for your reply. Looking at the Barnett kit does it matter what model I buy it for? I believe the ST4S uses ally plates? Any idea if the 'full' kits also include the dished plate or is that a ducati only part?

Roughly hw many TD's can I expect from a clutch, I am not too harsh however I will 'use' the slipper as god intended!

thanks, jack