180 or 190 profile on 6 inch rear rim? - Page 3

DJ Tera · 09-Jun-2004, 20:47

Sorry to dissapoint ya Tim but an inch is MUCH bigger than you think - evidently!

[Edited on 9-6-2004 by DJ Tera]

Jon · 09-Jun-2004, 23:54

Who's complaining over 1/2", 12mm, 1.2cm

Rattler · 10-Jun-2004, 10:00

Ah - but 1/2" is the difference between the id and od - right????

RickyX · 10-Jun-2004, 15:04

See this: 180/55 SuperCorsas are recommended for fitment to 5.5 or 6.0in rims!
http://www.metzelermoto.co.uk/produc...port_E2003.pdf

Also, for the SERIOUS tecchy:
http://www.atnet.it/lista/paper83.pdf

Mama mia...

[Edited on 10-6-2004 by RickyX]

DJ Tera · 10-Jun-2004, 15:59

The lips (its gettin worse

) on the wheel are about 3mm wide from what I remember - it's been so long (even worse

)

[Edited on 10-6-2004 by DJ Tera]

stimpy · 10-Jun-2004, 23:39

My std rims ( 3 spoke ally) measure 6+inch ish on the outside width. The magnesium marchesinis measure more than 1/2 inch more. In fact they are not far off 7 inches in total external width. Can't be bothered to measure too accuratley but will if anyone wants the exact figures.

Rattler · 11-Jun-2004, 10:31

Stimpy - that's what I mean about the measurements - your 3 spoke brembos would officially be 5.5" and the mags would be 6" - in all probability. That's from the internal diameter measurement (id).

Tim

Desmondo · 11-Jun-2004, 10:54

I measured my march-mags when they arrived and the internal measurement was dead on 6"

Rattler · 11-Jun-2004, 11:31

When did you get mags????
I thought you were too tight!!!!

Desmondo · 11-Jun-2004, 11:58

Bought some off Jasper. Not a case of too tight mate, just the right timing

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

09-Jun-2004, 20:47	#21
DJ Tera Registered Forum User Big Twin Posts: 1,724 Join Date: Aug 2002 Location: London Sorry to dissapoint ya Tim but an inch is MUCH bigger than you think - evidently! [Edited on 9-6-2004 by DJ Tera] Reply

09-Jun-2004, 23:54	#22
Jon Registered Forum User Ducati Corse Posts: 3,921 Join Date: Jun 2001 Location: Drayton Bassett, Staffs Mood: Tad more confident Who's complaining over 1/2", 12mm, 1.2cm Reply

10-Jun-2004, 10:00	#23
Rattler Registered Forum User WSB Hero Posts: 8,863 Join Date: May 2002 Location: Boys Town Mood: www.cantbearsed.co.uk Ah - but 1/2" is the difference between the id and od - right???? Reply

10-Jun-2004, 15:59	#25
DJ Tera Registered Forum User Big Twin Posts: 1,724 Join Date: Aug 2002 Location: London The lips (its gettin worse ) on the wheel are about 3mm wide from what I remember - it's been so long (even worse ) [Edited on 10-6-2004 by DJ Tera] Reply

10-Jun-2004, 23:39	#26
stimpy Registered Forum User Posts: 21 Join Date: Oct 2002 Location: Mostly play in Devon. My std rims ( 3 spoke ally) measure 6+inch ish on the outside width. The magnesium marchesinis measure more than 1/2 inch more. In fact they are not far off 7 inches in total external width. Can't be bothered to measure too accuratley but will if anyone wants the exact figures. Reply

11-Jun-2004, 10:31	#27
Rattler Registered Forum User WSB Hero Posts: 8,863 Join Date: May 2002 Location: Boys Town Mood: www.cantbearsed.co.uk Stimpy - that's what I mean about the measurements - your 3 spoke brembos would officially be 5.5" and the mags would be 6" - in all probability. That's from the internal diameter measurement (id). Tim Reply

11-Jun-2004, 10:54	#28
Desmondo Registered Forum User Big Twin Posts: 1,698 Join Date: Jan 2002 Location: Braintree, Essex. Mood: :devil: I measured my march-mags when they arrived and the internal measurement was dead on 6" Reply

11-Jun-2004, 11:31	#29
Rattler Registered Forum User WSB Hero Posts: 8,863 Join Date: May 2002 Location: Boys Town Mood: www.cantbearsed.co.uk When did you get mags???? I thought you were too tight!!!! Reply

11-Jun-2004, 11:58	#30
Desmondo Registered Forum User Big Twin Posts: 1,698 Join Date: Jan 2002 Location: Braintree, Essex. Mood: :devil: Bought some off Jasper. Not a case of too tight mate, just the right timing Reply