Ducati Sporting Club UK > DesmoDue Race Series > DesmoDue Parts For Sale & Wanted > Wanted Please

[Ghost]

Originally Posted by dunlop0_1

Is it the magnety bit you want Phil? I have one, as Kev said they vary in size. This is 108.9mm ID (3 phase).

109mm ID surely OD

Its a 583 motor so a single phase jobbie 2 yellow wires. I'm up at Jan's this weekend so when I get back I'll measure inside of the windings and the depth that's available on the crankshaft end.

[dunlop0_1]

Originally Posted by Ghost

109mm ID surely OD

Its a 583 motor so a single phase jobbie 2 yellow wires. I'm up at Jan's this weekend so when I get back I'll measure inside of the windings and the depth that's available on the crankshaft end.

Due to the current cold weather the coefficient of linier expansion affects the molecular structure of the caliper in such a way it manifests as a negative thus causing it to under read.

and I thought you where an engineer.

[skidlids]

Maybe it was the expansion/contraction properties of the Rotor that were subject to change from the cold weather casuing it to shring from 109mm to 108.9mm

or if they were digital calipers the battery volts were possibly pulled down in the cold casuing the reference voltage to drift and an error to occur

but whats 0.1mm between friends

[Ghost]

Originally Posted by skidlids

Maybe it was the expansion/contraction properties of the Rotor that were subject to change from the cold weather casuing it to shring from 109mm to 108.9mm

or if they were digital calipers the battery volts were possibly pulled down in the cold casuing the reference voltage to drift and an error to occur

but whats 0.1mm between friends

You know the old adage Kev, size matters.

[skidlids]

yep I know i need bigger wotsits to run nearer the front, then again I hear dodgy eyesight helps as the gap may look bigger than it actually is even if its only 0.1 of a millimeter

[dunlop0_1]

[Ghost]

Makes me smile does the banter on these cold nights, I don't smile much these days, as I'm still mentoring Victor Meldrew.

But all I want is a round magneticy thingy. that has a diameter with a 0.1 tolerance, or at least 3/5th's of fcukall.

[Ghost]

Originally Posted by dunlop0_1

Due to the current cold weather the coefficient of linier expansion affects the molecular structure of the caliper in such a way it manifests as a negative thus causing it to under read.

and I thought you where an engineer.

I reckon you are using a Chorley calibrated G cramp. I thought I was an engineer as well, but just found that I'm actually gay.