Valve clearances too tight to measure

Fudoshin · 11-May-2014, 22:23

Thanks, I'll give that a go..

dunlop0_1 · 12-May-2014, 06:16

As Kev said. Also are you sure the closer shims are seating correctly. Once they have been out even with the original half rings they can sometimes need quite a bit of persuasion to seat correctly.

Also do not try and make a measurement/adjustment for both opener and closer at the same time. Do the closer and then the opener.

Fudoshin · 12-May-2014, 13:16

Hi, was careful with the closers but will check again but didn't think to do the two measurements/adjustments separately... Top tip - thanks guys, going to get on it on Wednesday and will let you know- cheers again. JP

Fudoshin · 05-Aug-2014, 22:29

hi guys,
its been an age but wanted to say that I got the shims sorted and thanks to your advice it became pretty straight forward.
Much appreciated!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit

11-May-2014, 22:23	#1
Fudoshin Registered Forum User Posts: 6 Join Date: May 2014 Thanks, I'll give that a go.. Reply

12-May-2014, 13:16	#3
Fudoshin Registered Forum User Posts: 6 Join Date: May 2014 Hi, was careful with the closers but will check again but didn't think to do the two measurements/adjustments separately... Top tip - thanks guys, going to get on it on Wednesday and will let you know- cheers again. JP Reply

05-Aug-2014, 22:29	#4
Fudoshin Registered Forum User Posts: 6 Join Date: May 2014 hi guys, its been an age but wanted to say that I got the shims sorted and thanks to your advice it became pretty straight forward. Much appreciated! Reply