Registered Forum User
Bikes: 916 BP
Posts: 14
Join Date: Jun 2001
Location: Tonbridge, Kent
Mood: Marvellous
Not a happy bunny! Rear Sprocket
I'm worried!!! I've found some torque settings for the ally cover over the rear sprocket, 5 x nuts - 7 to 8 NM. I've tightened to this but there is small movement side to side in the new sprocket. I'm also concerned this is not very tight.
Is the movement ok & normal?
Should I have the nuts wirelocked as I've seen on some bikes?
Thanks for any advice,
Dave
916BP (fitting new Renthal carrier & cogs & Tsubaki Sigma chain)
Threaded Mode