Pressure Plate Bearing

900MAN · 30-Aug-2006, 14:34

How much hassle is it if you buy a pressure plate without the bearing?
Ta

antonye · 30-Aug-2006, 15:06

Push out, push in from what I have seen!

900MAN · 30-Aug-2006, 15:29

Just wasn't sure if you need any special equipment.
Mallet and wood time then (when I get the bits)

antonye · 30-Aug-2006, 16:18

Don't think you even need that much!

Paul James · 31-Aug-2006, 00:24

Probably pay to warm the plate in the oven before fitting the bearing as the fit is a slight interference, with manufacturing tolerances you could get one on the tight side.

final_edition · 31-Aug-2006, 00:38

Or put the bearing in the freezer overnight.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

30-Aug-2006, 14:34	#1
900MAN Registered Forum User 500SD Posts: 676 Join Date: Mar 2006 Location: essex Mood: 900 went 999 gone, Multi came and went, 749 Nero now Pressure Plate Bearing How much hassle is it if you buy a pressure plate without the bearing? Ta Reply

30-Aug-2006, 15:29	#3
900MAN Registered Forum User 500SD Posts: 676 Join Date: Mar 2006 Location: essex Mood: 900 went 999 gone, Multi came and went, 749 Nero now Just wasn't sure if you need any special equipment. Mallet and wood time then (when I get the bits) Reply

31-Aug-2006, 00:38	#6
final_edition DSC Club Member Big Twin Posts: 1,918 Join Date: Jan 2006 Location: Kent Mood: Having some tinnies and a barbie Or put the bearing in the freezer overnight. Reply