Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > General Motorcycles only > swingarm removal idea 748/9**

[Mello-Yellow]

Is it possible to remove the swingarm without fully removing the engine from the frame (998). I know of the prising open the frame method but not to keen on that one and have had an idea. Was thinking if i remove the rear engine bolt, loosen the front one so the back of then engine swings downwards would it leave enough clearence to get the swingarm out.

[TopiToo]

Hello Mello Yellow

Hello ste996

That's prity much what I did to get the swinging arm on,
lossen the two engine bolts, to allow the engine to drop
down just a touch. I also had the bike attached to a pulley
from the garage roof as it helped to lift the frame, and steady the bike.

Dont forget to grease the swinging arm bolt
on installation. Good luck.

TopiToo