Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Mounting the clocks

[Chrisiball]

Just fitted the new headlight housing to the 748r, since the old one was destroyed i couldnt tell how the clocks were mounted to the housing, Now i can see it rests on 2 rubber blocks, and it is bolted at the right hand side. (Only one bolt to hold the clocks on? is this right?) If thats how its mounted there must be a spacer because there is a gap between the housing and the clocks when it sits on the rubber blocks! So what is the spacer and what sort of bolt is it?

[neil748r]

From memory, there should be 3 rubber stand-offs, not 2. Couple of quid each from your dealer.

[skidlids]

yep 3 rubber standoffs isolate the clocks from the vibes. they are about 12-15mm long with smm threads at each end

[HANCYM]

You can also get these same rubber mounts from RS Components in corby