Quote:
Originally posted by phil_h
Dominic - There were some produced as a one off last year, but apparently the bloke isnt keen to do any more cos he didnt make any money out of them !
|
It wasn't that he didn't make any money - they actually only cost me a fiver to cover the raw materials - it just wasn't worth his time to knock out lots of sets because it took too long and therefore the associated cost in time would have been too high.
There have been lots of solutions offered up on the board, from simple plates that anyone could make at home, through to links to cheap rearsets that get knocked out of a cnc machine at a rate of a few hundred an hour!
antonye
Threaded Mode